Start by soldering the power connector pins
On the opposite side of the PCB place all the jacks and once they are all in place solder them on the back
Remove the anti rotation tabs from the potentiometers and put them in place following the circles on the PCB silkscreen, proceed to solder all of their legs
Put the LEDs in place following the colour scheme of the picture, do NOT solder anything yet
Join the front panel with the PCB and tighten the nuts of the jacks and potentiometers
From the back of the PCB push all the LEDs into their respective holes and solder the legs
Trim the extra LED legs, put the knobs on the potentiometers. Done!
